Language: Chinese line English

Industry new

Installation process of tap water booster pump

  The water flows to the low position, and it is a lot of ways to bring the water from the low place to the high place. Now we make the tap water booster pump, so that the water can be drained from the low place to the high place. For ease of use, we're here to learn about the installation of the running water booster pump. First, to find a suitable location, the installation position of the booster pump is to be found at the time of installation. The booster pump is installed flush with the water surface on the water pipe and is parallel to the water flow direction. When installing the pipe, care should be taken to minimize the pipe fluid resistance, so the pipe is not too much bent and as straight as possible. In order to enhance the control of the water injection of the booster pump, a check valve shall be added to the installation. At the same time, a filter can be installed in front of the intake pipe to filter the sediment, rust, suspended matter and other impurities in the tap water, so as not to let the impurities into the pump body, damage the impeller and affect the use.

The installed tap water booster pump can be tested to see if the tap water booster pump works normally and can be debugged in time.

CATEGORIES

CONTACT US

Contact: RuoTian.Zhong

Phone: 18300100005

Tel: 0539-8535670

Email: [email protected]

Add: Guangdong guangzhou tianhe balance sand too road sand road

Scan the qr codeClose
the qr code
宏图棋牌游戏 大象彩票APP 幸运赛车注册 盈多多彩票APP 好彩客登陆 广东11选5走势图 同城彩票注册 双赢彩票登陆 128彩票注册 广东11选5